Important Note: If you are using Cleanflight, please use the 1.11RC or newer software. Trying to load the 1.10 will cause your board to not work.
Included: Acro Naze, header pins.
Note that returns on these are not accepted after soldering. Please plug the board into your computer BEFORE you solder it to check it works.
These are clone boards. RadioC is very happy with the quality of these boards (in fact they are arguably better than the original), and they are fully covered by our standard warranty. They come preflashed with Cleanflight 1.11 or newer.
These change colour with every batch, so may not be black as pictured.
STM32F103CBT6 32-bit ARM Cortex M3 processor (72MHz, 3.3V)
Invensense MPU6500 MEMS accelerometer + gyro
Battery voltage monitoring
Built-in FrSky telemetry converter
Onboard USB for setup and configuration
Extra bright LEDs
Sonar pads w/resistors added for direct connection to 5V sonar
Weight: 6 grams (no headers, 8 grams with)
Sensors: MPU6500, BMP280
Acro Naze Rev 6b
Straight header pins