PLEASE NOTE: BOARDS ARE CURRENTLY SHIPPING IN THE COLOUR BLACK, COLOURS MAY VARY
This is the original Naze Rev 5 board as designed by Timecop. These boards, while a little long in the tooth now, are still fantastic in the air. The main reason these are still commonly used is the wealth of knowledge available about them online. While more modern boards exist, these are reliable, and any problem you may encounter with them has been solved by somebody else and the solution documented online.
Included: Naze board, 3-wide right angle header pins x6, 3-wide straight pins x6, 2-wide straight header pins x10, 2-wide right angle pins x1.
Note that returns on these are not accepted after soldering. Please plug the board into your computer BEFORE you solder it to check it works.
This is the full version of the Naze 32, which has 3 sensors for more precise flight, and options like altitude hold via the barometer. (The cheaper version has only 1 sensor).
These are clone boards. RadioC is very happy with the quality of these boards, and they are fully covered by our standard warranty.
These change colour with every batch, so may not be red as pictured.
are available here
5.3 grams (no headers, 7.3 grams with)
2000 degrees/second 3-axis MEMS gyro + accelerometer (MPU6050)
3-axis magnetometer (HMC5883L)
Pressure sensor (MS5611)
Flexible motor outputs, support various airframe types -
Quad/Hexa/Tri/Bi/Y4/Y6/Octo/Camera Gimbal. (Default is Quad-X)
Up to 8 ch RC input - supports standard receivers (PWM), PPM Sum receiver (FrSky, etc), or Spektrum Satellite receiver.
Built in FrSky telemetry inverter (shared w/main port)
Battery voltage monitoring
Modern 32-bit processor running at 3.3V/72MHz (STM32F103CB).
16Mbit onboard SPI flash
Onboard MicroUSB for setup and configuration
LEDs so bright, they will blind you
MultiWii-based configuration software for easy setup
rev5 hardware Naze32
Made in JAPAN
Designed for use with small indoor or small to mid-sized outdoor multirotor craft, or as a standalone camera stabilizer, the Naze32 flight control is simple to setup, with configuration based on the familiar “MultiWii” software.
These are always the latest Rev boards, currently in Red.