This all new Omnibus F4 pro is one of the most power flight control boards RadioC stocks. It packs almost every possible feature on board removing the need for additional hardware elsewhere on your racing drone.
This is the all new Omnibus F4 Pro. The board uses the F4 processor for even faster loop times and additional UART ports. It has an onboard OSD module, SD card reader, low noise IMU connected via SPI, a current and voltage sensor, and an on board BEC. This version introduces SmartAudio V2 control via J10 connector to you can control your compatible VTX (such as TBS Unify) via the OSD menu.
These are clone boards. RadioC is very happy with the quality of these boards, and they are fully covered by our standard warranty.
Flash Target File:
PPM and SBUS share UART3. Using either mode will require enabling RX_Serial on UART 3 within betaflight.
On-Board OSD (controlled by Betaflight, FC over SPI bus)
F4 Processor (F405)
5v 3a SBEC
Built-in Current Sensor
On-Board Video Filter (only can supply 5V to VTX and Camera)
SmartAudio V2 via J10
PWM, PPM, SBUS and Spektrum (DSM2) inputs.
1x Omnibus F4 Pro flight controller
Servo Wire (For Sbus/PPM Connection to Rx)