The X-Racer F303 V3.1 is the new standard in all round flight controller technology. Now armed with D-Shot support, and 8Khz MPU6000 for the smoothest possible flight, the X-Racer F303 V3.1 flight controller ticks every box on a racing drone pilots wish list. If you want to fly your racing drone competitively using the latest Betaflight software, this board is perfect for you.
This 3.1 is the latest version from RadioC and is in UK stock, and comes manufactured to the highest standards allowing us to supply it with the usual warranty.
So what is it about the X-Racer F303 V3.1 flight controller that makes it so great for racing drones? To start it comes with nothing but pin out style connections, meaning there are not awkward headers that must be used to connect things. This allows a much higher degree of customisation, with wires or pins able to protrude top or bottom.
The X-Racer F303 V3.1 flight controller is based on the F3 CPU, with 3 UART ports, it is fully PPM, SBUS, or PWM compatible, meaning it will run with just about any transmitter and receiver combo. The F303 has 16mb of built in RAM, allowing automatic black box recording of flight for post race analysis.
The X-Racer F303 V3.1 flight controller has full WS2812B LED support, VBAT for live voltage monitoring, a buzzer output for audible warnings, telemetry support, and is of course connectable to a wide range of add on modules such as GPS, radar, or whatever else you may wish to install.
This X-Racer F303 V3.1 flight controller board conforms to standard hardware mounting patterns, and thus is compatible with almost all modern drone racing frames, and will stack with any standard size PDB.
These are clone boards. RadioC is very happy with the quality of these boards, and they are fully covered by our standard warranty.
Built in high capacity black box featuring 16mb flash memory. This will allow you to store an entire days worth of flights while you are out in the field burning through multiple batteries and flights. Next generation F3 processor for efficient flight calculations and those lower loop time you've been reading about.
The size of the flight controller follows the form thats so typical in all the others allowing you to mount to the majority of the frames out on the market without the need of changing mounting holes on most base plates.
8 PWM I/0 lines for ESCs and added options you may choose.
Supports Sbus, SumH, SumD, Xbus, PPM, PWM recievers but has a recommended and weight saving direct connection specifically for Sbus, which is our recommended connection for flight control.
Buzzer port for audible lost model location.
Convenient pin outs for easy, reliable soldering.
Only available in Acro style, no barometer or magnetometer.
RadioC's X-Racer F303 V3.1 ship with Betaflight firmware. The Hex installed is X_RACERSPI (V3.1).
X-Racer F303 V3.1
SBUS Cable (JST Male>Male)