Home > Brands > Betaflight
Sort By:
Page of 1
BetaFlight F3 flight control board
BetaFlight F3 Flight Control Board Clone
Our Price: £29.99
Special Price: £13.00
Savings: £16.99
This is a clone board. They work fine, and are of good working quality. The only issue is the SD card port cannot be used without modification.

This F3 board features a 3A power draw giving users extra room for added attachments through the UART ports.

The six layer PCB is a more expensive design approach but was needed to give the ability to have a PDB that was capable of having wiring pads on both the top and bottom of the board. By using the six layer design we were able to increase the size of the pads and work around all the components all the while giving ESC connections in the corners of the board rather than bunching all connections on either the top OR the bottom.

Featuring a fully functioning OSD On Screen Display that can be configured to show different aspects of the flight in Betaflight this board will make configuring your OSD a very simple process.
Choosing your power supply for video is relatively simple. BetaFlight FC has two options, 5v and battery voltage. Choose your camera voltage by jumping RAM with either the 5V solder section or the Vbat solder section. (its recommended to use Vbat, Most cameras and Video transmitters can run off battery voltage) If using 5v it is recommended to only power your camera and get the power for Vtx from another source.


  • 3 UART ports
  • Built in configurable OSD
  • 3A 5v regulator
  • Built in current sensor/PDB
  • 8k/8k Support
  • Dshot Support
  • Buzzer Support
  • LED Support
  • SBus Support


  • STM 32 F3 Processor
  • MPU6000 Sensor Chip
  • Weight: 8.6 grams
  • Mounting Holes: 30x30mm
  • Input Voltage: 3-6S LiPo
  • Max Current (PDB): 100A continuous